INCREASING THE RIGIDITY OF AN ELASTIC WORKING TOOL FOR PROCESSING THIN SHEET METAL BY CREATING COMPOSITE MATERIAL BASED ON POLYURETHANE ELASTOMERS AND SYNTHETIC ARAMIDE FABRICS

Authors

  • I. Semenov Moscow State Technical University named after N.E. Bauman
  • D. Savchuk Moscow State Technical University named after N.E. Bauman

Keywords:

polyurethane, kevlar, aramid fabrics, elastic working tool

Abstract

Theoretical and practical aspects of reinforcement of elastic working tool

Author Biographies

I. Semenov , Moscow State Technical University named after N.E. Bauman

doctor tech. Sci., Professor of the Department of Equipment and Rolling Technologies

D. Savchuk , Moscow State Technical University named after N.E. Bauman

Master's student of the department "Equipment and rolling technologies"

Downloads

Published

2021-03-22

Issue

Vol. 2 No. 12(64) (2020)

Section

Статьи

License

Creative Commons License

This work is licensed under a Creative Commons Attribution-NoDerivatives 4.0 International License.

CC BY-ND

A work licensed in this way allows the following:

1. The freedom to use and perform the work: The licensee must be allowed to make any use, private or public, of the work.

2. The freedom to study the work and apply the information: The licensee must be allowed to examine the work and to use the knowledge gained from the work in any way. The license may not, for example, restrict "reverse engineering."

2. The freedom to redistribute copies: Copies may be sold, swapped or given away for free, in the same form as the original.